Transition metal
Seaborgium is a synthetic chemical element; it has symbol Sg and atomic number 106. It is named after the American nuclear chemist Glenn T. Seaborg. As a synthetic element, it can be created in a laboratory but is not found in nature. It is also radioactive; the most stable known isotopes have half-lives on the order of several minutes.
In the periodic table of the elements, it is a d-block transactinide element. It is a member of the 7th period and belongs to the group 6 elements as the fourth member of the 6d series of transition metals. Very few chemical reactions of seaborgium have been studied: only a few atoms at a time can be produced and these decay quickly. A few inorganic compounds and a carbonyl believed to be Sg(CO)6 have been synthesized. These experiments have confirmed that seaborgium behaves as the heavier homologue to tungsten in group 6.
In 1974, a few atoms of seaborgium were produced in laboratories in the Soviet Union and in the United States. The priority of the discovery and therefore the naming of the element was disputed between Soviet and American scientists, and it was not until 1997 that the International Union of Pure and Applied Chemistry (IUPAC) established seaborgium as the official name for the element. It is one of only two elements named after a living person at the time of naming, the other being oganesson, element 118.
Following claims of the observation of elements 104 and 105 in 1970 by Albert Ghiorso et al. at the Lawrence Livermore National Laboratory, a search for element 106 using oxygen-18 projectiles and the previously used californium-249 target was conducted. Several 9.1 MeV alpha decays were reported and are now thought to originate from element 106, though this was not confirmed at the time. In 1972, the HILAC accelerator received equipment upgrades, preventing the team from repeating the experiment, and data analysis was not done during the shutdown. This reaction was tried again several years later, in 1974, and the Berkeley team realized that their new data agreed with their 1971 data, to the astonishment of Ghiorso. Hence, element 106 could have actually been discovered in 1971 if the original data was analyzed more carefully.
Two groups claimed discovery of the element. Evidence of element 106 was first reported in 1974 by a Russian research team in Dubna led by Yuri Oganessian, in which targets of lead-208 and lead-207 were bombarded with accelerated ions of chromium-54. In total, fifty-one spontaneous fission events were observed with a half-life between four and ten milliseconds. After having ruled out nucleon transfer reactions as a cause for these activities, the team concluded that the most likely cause of the activities was the spontaneous fission of isotopes of element 106. …
Very few properties of seaborgium or its compounds have been measured; this is due to its extremely limited and expensive production and the fact that seaborgium (and its parents) decays very quickly. A few singular chemistry-related properties have been measured, but properties of seaborgium metal remain unknown and only predictions are available.
Seaborgium is expected to be a solid under normal conditions and assume a body-centered cubic crystal structure, similar to its lighter congener tungsten. Early predictions estimated that it should be a very heavy metal with density around 35.0 g/cm3, but calculations in 2011 and 2013 predicted a somewhat lower value of 23–24 g/cm3.
Seaborgium is the fourth member of the 6d series of transition metals and the heaviest member of group 6 in the periodic table, below chromium, molybdenum, and tungsten. All the members of the group form a diversity of oxoanions. They readily portray their group oxidation state of +6, although this is highly oxidising in the case of chromium, and this state becomes more and more stable to reduction as the group is descended: indeed, tungsten is the last of the 5d transition metals where all four 5d electrons participate in metallic bonding. …
Superheavy elements such as seaborgium are produced by bombarding lighter elements in particle accelerators that induces fusion reactions. Whereas most of the isotopes of seaborgium can be synthesized directly this way, some heavier ones have only been observed as decay products of elements with higher atomic numbers.
Depending on the energies involved, fusion reactions that generate superheavy elements are separated into "hot" and "cold". In hot fusion reactions, very light, high-energy projectiles are accelerated toward very heavy targets (actinides), giving rise to compound nuclei at high excitation energy (~40–50 MeV) that may either fission or evaporate several (3 to 5) neutrons. In cold fusion reactions, the produced fused nuclei have a relatively low excitation energy (~10–20 MeV), which decreases the probability that these products will undergo fission reactions. As the fused nuclei cool to the ground state, they require emission of only one or two neutrons, and thus, allows for the generation of more neutron-rich products. The latter is a distinct concept from that of where nuclear fusion claimed to be achieved at room temperature conditions (see cold fusion).
Seaborgium has no stable or naturally occurring isotopes. Several radioactive isotopes have been synthesized in the laboratory, either by fusing two atoms or by observing the decay of heavier elements. …