Actinide
Mendelevium is a synthetic chemical element; it has symbol Md (formerly Mv) and atomic number 101. A metallic radioactive transuranium element in the actinide series, it is the first element by atomic number that currently cannot be produced in macroscopic quantities by neutron bombardment of lighter elements. It is the thirteenth actinide, the ninth transuranic element, and the first transfermium; it is named after Dmitri Mendeleev, the father of the periodic table.
Like all the transfermiums, it can only be produced in particle accelerators by bombarding lighter elements with charged particles. The element was first produced in 1955 by bombarding einsteinium with alpha particles, the method still used today. Using commonly-available microgram quantities of einsteinium-253, over a million mendelevium atoms may be made each hour. The chemistry of mendelevium is typical for the late actinides, with a dominant +3 oxidation state but also a +2 oxidation state accessible in solution. All known isotopes of mendelevium have short half-lives; there are currently no uses for it outside basic scientific research, and only small amounts are produced.
Mendelevium was the ninth transuranic element to be synthesized. It was first synthesized by Albert Ghiorso, Glenn T. Seaborg, Gregory Robert Choppin, Bernard G. Harvey, and team leader Stanley G. Thompson in early 1955 at the University of California, Berkeley. The team produced 256Md (half-life 77.7 minutes) when they bombarded an 253Es target consisting of only a billion (109) einsteinium atoms with alpha particles (helium nuclei) in the Berkeley Radiation Laboratory's 60-inch cyclotron, thus increasing the target's atomic number by two. 256Md thus became the first isotope of any element to be synthesized one atom at a time. In total, seventeen mendelevium atoms were detected. This discovery was part of a program, begun in 1952, that irradiated plutonium with neutrons to transmute it into heavier actinides. This method was necessary because of a lack of known beta decaying isotopes of fermium that might allow production by neutron capture; it is now known that such production is impossible at any possible reactor flux due to the very short half-life to spontaneous fission of 258Fm and subsequent isotopes, which still do not beta decay - the fermium gap that, as far as we know, sets a hard limit to the success of neutron capture processes.
To predict if the production of mendelevium would be possible, the team made use of a rough calculation. …
In the periodic table, mendelevium is located to the right of the actinide fermium, to the left of the actinide nobelium, and below the lanthanide thulium. Mendelevium metal has not yet been prepared in bulk quantities, and bulk preparation is currently impossible. Nevertheless, a number of predictions and some preliminary experimental results have been done regarding its properties.
The lanthanides and actinides, in the metallic state, can exist as either divalent (such as europium and ytterbium) or trivalent (most other lanthanides) metals. The former have fns2 configurations, whereas the latter have fn−1d1s2 configurations. In 1975, Johansson and Rosengren examined the measured and predicted values for the cohesive energies (enthalpies of crystallization) of the metallic lanthanides and actinides, both as divalent and trivalent metals. The conclusion was that the increased binding energy of the [Rn]5f126d17s2 configuration over the [Rn]5f137s2 configuration for mendelevium was not enough to compensate for the energy needed to promote one 5f electron to 6d, as is true also for the very late actinides: thus einsteinium, fermium, mendelevium, and nobelium were expected to be divalent metals. The increasing predominance of the divalent state well before the actinide series concludes is attributed to the relativistic stabilization of the 5f electrons, which increases with increasing atomic number. …
The lightest isotopes (244Md to 247Md) are mostly produced through bombardment of bismuth targets with argon ions, while slightly heavier ones (248Md to 253Md) are produced by bombarding plutonium and americium targets with ions of carbon and nitrogen. The most important and most stable isotopes are in the range from 254Md to 258Md and are produced through bombardment of einsteinium with alpha particles: einsteinium-253, −254, and −255 can all be used. 259Md is produced as a daughter of 259No, and 260Md can be produced in a transfer reaction between einsteinium-254 and oxygen-18. Typically, the most commonly used isotope 256Md is produced by bombarding either einsteinium-253 or −254 with alpha particles: einsteinium-254 is preferred when available because it has a longer half-life and therefore can be used as a target for longer. Using available microgram quantities of einsteinium, femtogram quantities of mendelevium-256 may be produced.
The recoil momentum of the produced mendelevium-256 atoms is used to bring them physically far away from the einsteinium target from which they are produced, bringing them onto a thin foil of metal (usually beryllium, aluminium, platinum, or gold) just behind the target in a vacuum. This eliminates the need for immediate chemical separation, which is both costly and prevents reusing of the expensive einsteinium target. …
Seventeen isotopes of mendelevium are known, with mass numbers from 244 to 260; all are radioactive. The longest-lived isotope is 258Md with a half-life of 51.6 days. Nevertheless, the shorter-lived 256Md (half-life 77.7 minutes) is more often used in chemical experiments because it can be produced in larger quantities from einsteinium, as 258Md would require 255Es, of which significant quantities are available only as a minor component of an isotopic mixture.
The half-lives of mendelevium isotopes mostly increase smoothly (apart from odd/even effects) toward higher mass, up to 258Md, then decrease (as indicated by what experimental data is available) as spontaneous fission becomes the dominant decay mode; the second longest-living isotope is 260Md, the heaviest known, with a half-life of 27.8 days. Mendelevium is the last element that has any known isotope with a half-life longer than a day.
Mendelevium-256, the currently most important isotope of mendelevium, decays about 90% through electron capture and 10% through alpha decay. It is most easily detected through the spontaneous fission of its electron capture daughter fermium-256, but in the presence of other nuclides that undergo spontaneous fission, alpha decays at the characteristic energies for mendelevium-256 (7.205 and 7.139 MeV) can provide more useful identification.
Though few people come in contact with mendelevium, the International Commission on Radiological Protection has set annual exposure limits for the most stable isotope. For mendelevium-258, the ingestion limit was set at 9×105 becquerels (1 Bq = 1 decay per second). Given the half-life of this isotope, this is only 2.48 ng (nanograms). The inhalation limit is at 6000 Bq or 16.5 pg (picograms).